NANOSIK® 6 in 1 Ponies
Declaration of certification: Prohlaseni_NANOS_en
The package contains:
- 5x SPURTEX® VS Premium Nano face mask with pony print
- the face masks are certified according to the ČSN EN 14683+AC standard
- filtration efficiency > 95%
- high breathability
- hand-sewn, perfectly shapable
- effectively protects against influenza
- 1x Unisanol disinfectant 20 ml for nanofibre products
Category: | Face masks and respirators |
---|
SPURTEX® VS Premium Nano face mask
-
nanolayer deposited on viscose (bio-based product)
-
viscose is produced from renewable resources
-
mechanical filtration using nanofibres
-
filtration efficiency at FFP2 level
-
high breathability
-
hand-sewn
-
mouldable section around the nose
-
fits snugly to the face and holds its shape
-
white elastic nylon elastics for grip
-
the face mask is disposable but can be sterilised up to 5 times in the most urgent cases, using disinfectant suitable for nanofibre products
-
Czech manufacturer SPUR
- more ( https://eshop.spur.cz/nanorouska-spurtex-vs-premium/ )
Face mask size
55 mm x 153 mm
Handling the NANO face mask
Disinfection SPURTEX® Unisanol
for immediate deactivation of viruses and bacteria and reuse of SPURTEX products
- can also be used as a disinfectant for hands and other surfaces
- eliminates microorganisms
- ethanol-based disinfectant
- disinfection developed in cooperation with Tomas Bata University in Zlin
- more ( https://eshop.spur.cz/dezinfekce-spurtex-unisanol/ )
Disinfection instructions for SPURTEX® Unisanol
It is advisable to disinfect this material after each use of the fac mask/respirator. It is recommended to wash your hands thoroughly before and immediately after disinfection (antibacterial gel).
Shake the disinfectant bottle thoroughly before use. Spray the mask/respirator with disinfectant on the outside and inside. When spraying the material, keep a distance of approx. 15 cm, apply the spray in an even (no maps on the material) amount over the entire surface (ears). It is sufficient to spray 2 to 3 times on each side of the material. Do not apply spray on respirator/mask if it is worn on the face.
After thoroughly disinfecting the material, allow the face shield / respirator to air dry (24 hours is recommended, to reduce the risk of breathing in residual alcohol vapours). It is not recommended to use dryers to dry the material as mechanical damage to the filter layer may occur. In addition, increased thermal stress on the material using a microwave oven or hair dryer is not recommended.
The mask/respirator can be reused after thorough drying. It is best to allow the material to dry and air out overnight to prevent inhalation of residual disinfectant. This process can be repeated up to 5 times (depending on the wear of the face mask/respirator) without affecting the filtering functionality of the material.